Getting My cheddite primers vs winchester 209 To Work

Getting My cheddite primers vs winchester 209 To Work

Blog Article

Possibly nothing you can do about this, since it is frequently caused because the hulls have gotten damp and the initial primer and metallic head have began to corrode, Though there might not be some actual evidence of it.



Can make me Imagine they are very sizzling. Truthfully I take advantage of cheddites for every little thing now, it’s all that’s out there. Lots of good data available too.

Winchester ensures better sensitivity For additional favourable firing in all guns, very carefully-controlled weights of primer mixtures, consistency in dimension and good quality, specific measurements and tolerances for anvil heights and security in extremes of temperatures and humidity.

The challenge with seating any primer in a very Remington hull is 2 fold and it has nothing at all to do Along with the brand name of primer. The Remington hull is a tiny bit distinctive than the usual Winchester or Federal GM hull. The Remington hull is a little bit further across the primer pocket and Which means You should lower rammer tube, not quite a bit but a little bit.

The Trap shooter Discussion board has Proportions of all primers used in a shotgun application, and they are all ROUGHLY a similar. Whether or not the output is identical normal overall performance, I can't say.

The load I am applying just isn't posted by Alliant, as they don't publish A lot data for Remington hulls and Winchester primers. I winchester 748 load data did, having said that, email them, and so they claimed that in the force the Rem primer/Rem hull the recipe calls for, they felt it had been Protected. Here are the details:

This really is an older thread, you may not receive a response, and could be reviving an previous thread. Make sure you take into account developing a new thread.

I labored with laboratories For a long time And that i observed plenty of errors. All good laboratories have stringent QA/QC suggestions which if not strictly adhered to, will mechanically invalidate data. I want to see Precision's Licensed standards and calibration data for openers.

Include to estimate Only show this person #fifteen · Dec 4, 2022 (Edited) 'I get it done continuously and my gun did not blow up' isn't going to seriously answer An important problem, which is the load in spec or not. Not that arduous to test a load when there is any query.

I was equipped to acquire various thousand Cheddite 209 primers and a number of other thousand Federal 209A primers. I'm trying to determine the principal difference between the two (if any).

All over again, my commendation to templetk-- many good indicators including the truth he examined ten rounds so his data can create good SD results; and his SDs were very limited, indicating to me that he in truth possibly was incredibly diligent in his loading strategies.

It's a fool's errand to try to Assess a person primer style to a different. If it could be carried out, an individual would have completed a chart that when compared them. That there's no chart is proof it cannot be completed.

I did not say I'm sure more than any individual at Alliant or almost every other powder manufacturer. All I have said is considering the data, it is evident which the Cheddite 209 just isn't near to a immediate substitute for your Winchester 209.

winders mentioned: Sure, there are several recipes where you could substitute the Winchester 209 primer Together with the Cheddite 209 primer. However the pressure would Usually be employ as would the velocites.